In your box you will find 4 modules, 4 locking cylinders, butyl putty, an adaptor, a hex key, 2 sets of keys and a key card. Lay them out in the boot of your car to ensure a smooth and easy installation.

Remove center cap with butyl putty. Caution be careful not to ruin the protruding emblem.

Insert locking ring at an angle with edge with the arrow mark first towards the lug.

Install the module with cut aligned towards the same lug.

Engage the centre bolt and tighten firmly using adaptor and hex key. You should require at least 3 full turns.

Don’t use impact wrench.
Min torque 35-40 Mm/25-30 ft-lb
Re-torque after 100km/60 miles

This is the detailed description that will appear below the media.

Insert the cylinder lock with the key, turned to locked position and remove key.

This is the detailed description that will appear below the media.

Re fit the center cap. Snap your centre cap back onto the Rimgard lock.

This is the detailed description that will appear below the media.

Remove the centre cap by placing the remover in the cut and pushing it up.

Reminder NOTES

Store Hex key and adaptor in your vehicle. We recommend keeping it in the box you received your locks in.

Keep one key with your car key incase of an immediate need to remove the locks.

spare key and key card to be kept in a safe space away from the vehicle.

MAKE SURE TO REGISTER YOUR KEY BY SWIPING LEFT

Registering your keys ensures that we are able to help incase you need a replacement.