What is in your box

In your box you will find....... lay them out in the boot of your car to ensure a smooth and easy installation.

Grab your putty

This is the detailed description that will appear below the media.

Remove center cap

Remove center cap with butyl putty. Caution be careful not to ruin the protruding emblem.

Grab your retention ring

This is the detailed description that will appear below the media.

Insert retension ring

This is the detailed description that will appear below the video.

Grab your module

This is the detailed description that will appear below the video.

Install the module

Install the module with cut aligned towards the same lug.

Grab your adaptor and hex key

This is the detailed description that will appear below the media.

Tighten centre bolt

Engage the centre bolt and tighten firmly using adaptor and hex key. You should require at least 3 full turns.

Grab your cylinder lock

This is the detailed description that will appear below the media.

Insert the cylinder

Insert the cylinder lock with the key, turned to locked position and remove key.

Grab your centre cap

This is the detailed description that will appear below the media.

Re fit the center cap

Re fit the center cap. Snap your centre cap back onto the Rimgard lock.

Centre cap remover

This is the detailed description that will appear below the media.

Centre cap remover

Remove the centre cap by placing the remover in the cut and pushing it up.

Register your key

Welcome to step 1! Follow the instructions carefully.

This is the detailed description that will appear below the media.